6540A REV C Norge Washer Parts List

Door shelf retainer bar (rack-door)

This refrigerator door shelf rack is an attachment for your refrigerator door to hold small items in your fridge, such as condiments. The door rack attaches to the inside of the refrigerator door to hold food items on the door shelves. The rack may need to be replaced if it is warped or broken. It measures approximately 25 inches long, 6 inches deep, 3 inches high, and is white in color. It is sold individually.

Door shelf (refrigerator door shelf bin)

This original equipment manufacturer Door Shelf is a white plastic part which holds items inside of your freezer or refrigerator door. It is roughly 10 inches long by 4 inches high by 5.5 inches wide. It can be used in the freezer or refrigerator and is very easy to repair. All you need to do is snap the new door bin into place, which requires no tools. This part is sold individually and not as part of a set, even though your refrigerator may take more than one of this part.

Refrigerator handle set (2 pieces) - white (door handle - white)

Rack slide end cap

This white rack track stop is used for your upper dishrack track to prevent the rack from sliding off the slide rail. If your rack is falling off the track, you may need to replace the track stop. This is a genuine OEM part and is sold individually.

Refrigerator crisper drawer with handle (use wpl 2188664)

This clear convertible meat drawer can be used to store meats or vegetables. It has its own cold air duct to allow cold air from the freezer to flow into the drawer. You could have a broken or faulty drawer if you find that the food being kept within is spoiling or drying out quickly. The drawer should slide open and closed with ease. If your drawer will not easily slide open or closed, check the tracks that the drawer slides on. If the tracks are not damaged, the drawer itself could be at fault and should be replaced. This part measures approximately 16 7/16 inches wide x 14 5/16 inches deep x 7 5/8 inches high, and is a genuine OEM replacement part. It is sold individually.

Crisper support - rear (shelf support stud)

This rear crisper cover support mounts to the inside of the cabinet wall to support the rear crisper cover. The support is held in place by a locking pin. If your shelf is not level or the drawer is not opening and closing properly, you may need to replace this part. This is a genuine OEM part and is sold individually.

Light bulb - 40w (sub 0053437)

This part is the exterior replacement light bulb, with a small screw base, for your microwave. If your light bulb is burnt out, it will not be able to do this, and will need to be replaced. Before you change the bulb, be sure to check that the light socket still works, as it may need to be replaced as well. This bulb is 40 watts, is sold individually and is a genuine OEM part. Remember to disconnect the microwave from the power source before you begin this repair.

Replacement ice maker (sub r0156669)

This is a replacement ice maker assembly. The ice maker receives water from the water inlet valve and will freeze until ice cubes are formed. Once the water has been frozen the cubes will be ejected from the mold in to the ice bucket. The ice maker will continue the process until the ice bucket has reached the limit. If your ice maker is not making ice you may need to replace this part. Disconnect the power and water supply before starting your repair. This ice maker is a genuine OEM part. NOTE: This part has been updated by the manufacturer and does not include the cover, ice level arm or the wire harness. You can reuse those from the original ice maker.

Surface burner knob (knob, switch)

This genuine OEM surface burner knob is a little under two inches in diameter. It is a black knob with gray numbering indicating the temperature level of the surface burner: low, medium, high, off, and lite. This part lets you control the amount of heat coming from the burner element. The knob is made entirely of plastic, it will accept a D shaped shaft and is sold individually.

Light bulb - 40w (oven light bulb)

This 40-watt light bulb has a standard screw-in base. It is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.

Dishwasher bottom door gasket (lower door seal)

This gasket goes on the bottom of the dishwasher door to create a tight seal between the tub and the outer edge of the door. If the gasket is cracked or broken, it will need to be replaced to keep water from leaking out on to the floor. The gasket is approximately 23” long and is a genuine OEM part. It is recommended that once you have installed the gasket to leave the door closed for a few hours to make sure the gasket is properly sealed.

Dryer door switch (door switch assembly)

This 3-wire with leads dryer door switch is an on and off mechanism that prevents the dryer from operating while the door is open. The dryer will not operate until the door switch signals that the dryer door is closed. If the dryer won’t start, the lever broke off, or the switch shorted out, the appliance will not operate and the part will need to be replaced. This switch is a genuine OEM part and replaces the 2-wire switch. Please remember to disconnect the power to the dryer before starting the repair.

Chrome drip bowl - 6" (use 5303280336)

The 6-inch drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This chrome drip bowl is compatible with electric ranges that utilize plug-in surface burners. This bowl measures approximately 8-inches in diameter. If your drip bowl becomes damaged or rusted it is best to replace the drip bowl to avoid any grease or spill from dripping down inside the range. This is a genuine OEM part and is sold individually.

Drip bowl - 6 inch (sub 74001212)

This six-inch chrome drip bowl is intended for use with rolled terminal-style plug in surface element units. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.

Refrigerator water filter (sub 67003523)

This water filter has been updated by the manufacturer. It may appear different but will still function the same. No tools are required to replace your water filter. It is sold individually. This water filter is a genuine OEM part and should be changed every 6 months.